Filter
Top Products
special code is easy to find in your favorite TV program guide or daily newspaper. Here's a sample page from
TV Guide showing PlusCode numbers next to each program.
Your local channels may be different from the VCR Plus+ channel codes. To get ready to record with the VCR
Plus+ system you need to assign your local broadcast and cable channel numbers to the VCR Plus+ channel
codes already stored in your VCR's memory. This is called channel setup and you do it using the on-screen
Easy Guide System and the following step-by-step instructions. Then you will be ready to begin VCR Plus+
recording, also using the on-screen Easy Guide System.
VCR Plus+ and PlusCode are trademarks of Gemstar Development corp.
Note: You cannot use the VCR Plus+ system for a timed recording of a DSS program. Program the timer
manually (see page 47).
Channel setup
Before you begin
1 Look for a listing like this one in your local TV program guide or Sunday newspaper TV section. Notice the
small numbers to the right of the station name.
These are the VCR Plus+ channel numbers that you will use in the channel setup procedure.
2 Make a list of the VCR Plus+ channel numbers and the channel numbers you are receiving them on. If there
are any difference, YOUR channel numbers must be assigned to the corresponding VCR Plus+ number. (See
Example)
Note in the example that the channel numbers are the same except for 20 (received on channel 8) and 42