Filter
Top Products
19
Operating Components not Reached by the Remote
Controller Signals (IR IN/OUT)
In order to use the remote controller to control the DPS-8.3 from a
remote location, you will need to prepare a multi-room kit (sold
separately such as one of those given below:
• Integra’s Multi-Room System kit (IR Remote Controller Extension
System).
• Multiroom A/V distribution and control system such as those from
Niles
®
and Xantech
®
.
If the DPS-8.3 is located inside a cabinet or other enclosure
where the infrared rays from the remote controller cannot
enter, then operation with the remote controller will not be
possible. In such a case, it will be necessary to install a
remote sensor at a location outside of the cabinet for the
infrared rays from the controller to reach.
In this situation, you will need to use a commercially-available
IR emitter. Connect the mini plug of the IR emitter to the IR
OUT terminal on the DPS-8.3. Then place the IR emitter on
the remote sensor of the component or facing it. When the IR
emitter is connected, only the signal input to the IR IN
terminal is output to the IR OUT terminal. The signal input
from the remote sensor on the front of the
DPS-8.3 will not be output to the IR OUT terminal.
DPS-8.3
OUT
IN
IR
Make connection as shown below. Do not plug the equipment
into the power source until the connection is completed.
IR IN
DPS-8.3
In the
cabinet
Remote Controller
Connecting
block
IR Receiver
: Signal flow
IR IN
IR OUT
Connecting
block
IR Receiver
DPS-8.3
IR Emitter
Remote Controller
other
component
: Signal flow
Remote control
sensor
DPS-8.3
OUT
IN
IR
from connecting block
Mini plug cable
from connecting block
Mini plug cable
Mini plug
Emitter
Mini plug cable
IR Emitter
:Signal flow
If the remote controller signal does not
reach the DPS-8.3 remote sensor
If the remote controller signal does not
reach other components