Filter
Top Products
66
6
7
Programming procedure
4
5
Press and hold down the button on
the other remote control unit that
corresponds to the command you
want to program until the Send/
Learn indicator flashes twice to
indicate that the command has
been successfully programmed.
After flashing twice, the Send/Learn
indicator lights up again.
Repeat steps 3 and 4 to program
other commands within the same
mode. Repeat step 2 to 4 to
program commands to the other
mode.
Press the Mode button (VCR or TV)
that you pressed in step 2 to
complete the programming.
Use the remote controller to
perform the newly learned
command to confirm that it was
learned correctly.
Notes
• Some buttons have already been programmed to control
functions of an Integra/Onkyo receiver. Therefore, it is
recommended to program additional functions of the receiver that
are not already programmed in the remote controller.
• If no buttons are pressed for more than 30 seconds during the
programming, or if you perform an invalid operation, the
Send/Learn indicator flashes three times quickly and the remote
controller exits the programming mode. Resume programming
from step 2.
• If you perform an invalid operation during programming, the
Send/Learn indicator flashes three times quickly and the remote
controller exits the programming mode. Resume from Step 2.
• When you want to program a command to a button to which you
have already programmed a command, simply follow the same
procedure and programming for that button will be overwritten.
• The remote controller uses infrared rays to send its commands,
as do most other remote control units. Though most remote
control units can be memorized by the remote controller, be
aware that some remote control units use a system that is quite
different from the remote controller and therefore may not be able
to be programmed.
• Some remote control units have a single button that performs
multiple functions (for example, the function may change each
time the button is pressed). If this is the case, each function must
be programmed to a separate button on the remote controller.
• Once you have programmed the commands from the other
remote control unit, refer to the instructions supplied with the
other component to operate.
• Make sure that both the remote controller and the other remote
control unit have new batteries. If either of them has batteries
that are low, you may not be able to program the commands of
the other remote control unit properly into the remote controller.
• Removing the batteries from the remote controller for at least 10
minutes erases all of the commands that have been programmed
in the remote controller.
Programming the Commands of Other Remote
Control Units into the Remote Controller