Filter
Top Products
10
BIOS Setup Information
WBX-6200F-V is equipped with the AMI BIOS stored in Flash ROM.
This BIOS has a built-in Setup program that allows users to modify
the basic system configuration easily. This type of information is
stored in CMOS RAM so that it is retained during power-off periods.
When system is turned on, WBX-6200F-V communicates with
peripheral devices and checks its hardware resources against the
configuration information stored in the CMOS memory. If any error
is detected, or the CMOS parameters need to be initially defined,
the diagnostic program will prompt the user to enter the SETUP
program. Some errors are significant enough to abort the start-up.
Entering Setup
Turn on or reboot the computer. When the message “Hit <DEL> if
you want to run SETUP” appears, press <Del> key immediately to
enter BIOS setup program.
If the message disappears before you respond, but you still wish to
enter Setup, please restart the system to try “COLD START” again
by turning it OFF and then ON, or touch the "RESET" button. You
may also restart from “WARM START” by pressing <Ctrl>, <Alt>,
and <Delete> keys simultaneously. If you do not press the keys at
the right time and the system will not boot, an error message will
be displayed and you will again be asked to,
Press <F1> to Run SETUP or Resume