JVC 50059704 Flat Panel Television User Manual


 
ENGLISH - 9 -
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to oper-
ate on 220 - 240 V AC, 50 Hz.
 After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The RF Input
Socket
 Connect the aerial or cable TV plug to the RF
input socket located at the back of the TV
and connect the cable plug coming out from
the TV out socket located at the devices (VCR,
DVB etc.) to this socket as well.
How To Connect Other Devices
IMPORTANT: Switch off the TV before connect-
ing any external device.
Sockets for external connections are at the
back and side of the TV. For connection of other
devices via Euroconnector refer to the manu-
als of the related devices.
Inserting Batteries In The Remote
Control Handset
 Place the batteries in the right directions as
seen below.
 Remove the battery cover located on the back
of the handset by gently pulling upwards from
the indicated part.
 Insert two AA/R6 dry cell or equivalent type
of batteries inside.
 Replace the battery cover.
NOTE: Remove batteries from remote con-
trol handset when it is not to be used for a long
period.Otherwise it can be damaged due to
any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press On/Off switch at the rear of the
TV. Then the TV switches itself to stand-by
mode and the power lamp becomes red lo-
cated on the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press 
/ I, "-P/CH" or "P/CH+" button at the
top of the TV or press   or   button
on the remote control, so that last switched off
programme is selected.
By either ways the TV will switch on and the
power lamp becomes green.
To switch the TV off:
 Press the stand-by button on the remote
control, so the TV will switch to stand-by
mode and the power lamp will become RED,
or,
Press the  / I button located on the top of
the TV, so the TV will switch off and the power
lamp will become RED.
To switch the TV off completely press On/Off
switch at the rear of the TV and remove the
mains plug from the socket.
01-ENG-3008W-17MB11-1860UK-(LT-30E45SU)-50059494.p65 07.12.2004, 10:429