Filter
Top Products
26 EN
SIMPLE PLAYBACK AND RECORDING (cont.)
Simple
Recording
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover the
hole with adhesive tape before inserting the cassette.
SELECT RECORDING
CHANNEL
2
Press CH5
∞
. Or press the appropriate NUMBER keys,
then press ENTER. (The channel changes after a few
seconds whether you press ENTER or not.)
● If you use the RF connection, by pressing the TV/VCR
button, select VCR mode to view the program to be
recorded.
SET TAPE SPEED
3
Press SP/EP to set the recording speed.
START RECORDING
4
Press and hold REC and press PLAY on the remote
control, or press REC on the VCR's front panel.
Active Video Calibration takes place at the beginning
of both the first SP and the first EP recording after
inserting the cassette (when RECORD Active Video
Calibration is set to "ON",
੬ pg. 37).
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
● During record pause, you can change the recording
channel by using the CH5
∞
buttons or NUMBER keys.
Active Video Calibration will not take place if the
tape speed is changed while in record pause mode.
STOP RECORDING
6
Press STOP or STOP/EJECT. Then press STOP/EJECT to
remove the cassette.
1
2
3
456
7
8
0
9
3
¶
4¢
78
1¡
q
STOP
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
● To prevent accidental recording on a recorded cassette,
remove its record safety tab.
To record on it later, cover the hole with adhesive tape.
Record safety tab
Accidental erasure prevention
TV/VCR
ENTER
PLAY
REC
PAUSE
NUMBER
CH
SP/EP
PAUSE
STOP/EJECT
PLAY
REC
CH
SP/EP