Filter
Top Products
EN 49
EDITING
Edit To Or
From Another
VCR
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the player’s VIDEO OUT
and AUDIO OUT connectors and the recorder’s VIDEO
IN and AUDIO IN connectors.
● If using another VCR with an S-VIDEO input or
output connector, it is recommended to use the S-
VIDEO connection to minimize picture degradation
while editing.
● When using your VCR as the recorder and a monaural
VCR as the player, connect the player’s AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER’S INPUT
MODE
3
Set to AUX. With this VCR, press NUMBER key “0” (AU
appears on the front display panel in place of a channel
number).
NOTE:
When using this VCR as the recorder, be sure to select the
correct AUX input connector (depending on which input
connectors you use) at the Aux Input Screen. To select the
correct AUX input connector, follow steps 4, 5, 9, 10, 14
from the "Edit From A Camcorder" section,
੬
pg. 50 – 51.
ENGAGE TAPE DUBBING
MODE
4
Follow steps 4, 5, 12 – 14 from the "Edit From A
Camcorder" section (੬ pg. 50 – 51)
START PLAYER
5
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY (
੬
pg. 30).
START RECORDER
6
Set to its record mode.
NOTES:
●
Be sure to set "TAPE DUB MODE" back to "OFF" when you
finish editing.
●
When "TAPE DUB MODE" is set to "ON" Active Video
Calibration is deactivated in order to provide better picture
quality edits.
●
If you use an auxiliary input to connect a cable box or DBS
receiver make sure that the correct input ("FRONT VIDEO",
"REAR S-VIDEO" or "REAR VIDEO") is selected after you have
finished editing (
੬
step 10, page 51).
Your VCR
Player
VIDEO OUT
S-VIDEO INVIDEO IN
S-VIDEO OUT
Advantages Of S-VHS Editing
S-VHS allows you make high resolution video recordings
when dubbing from one VCR to another.
You can edit from VHS to S-VHS, from S-VHS to VHS, or
from S-VHS to S-VHS.
● From VHS to S-VHS (VIDEO-VIDEO connection): Record
VHS playback signals in the S-VHS mode. Although the
picture quality is inherently limited by the orignal VHS
source material, the edited tape has better picture quality
than those made by VHS-to-VHS editing.
● From S-VHS to VHS (VIDEO-VIDEO connection): Because
the picture quality of the source material is very high, the
edited tape has better picture quality than those made by
VHS-to-VHS editing.
● From S-VHS to S-VHS (S-VIDEO connection): A high
resolution copy is made of a high resolution original S-
VHS tape with minimal picture degradation. This is the
preferred method of video dubbing.
S-Video
cable
(supplied)
AUDIO IN
Another VCRRecorder
AUDIO OUT
Audio/Video cable
(supplied)