Filter
Top Products
58 EN
SPECIAL FEATURES (cont.)
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver's remote
control.
ENTER DBS RECEIVER
BRAND
2
While holding down CABLE/DBS on the VCR’s remote
control, press MBR SET and use the NUMBER keys to
enter the DBS receiver brand number from the chart
below and then press STOP.
Follow the example shown below.
● Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
3
First, while holding down CABLE/DBS, press POWER
to see if the DBS receiver's power goes off as it should.
If it does, try other functions.
● To operate your DBS Receiver, while holding down
CABLE/DBS, press the corresponding button:
POWER, CH5
∞
, NUMBER keys (or ENTER).
● Depending on the DBS receiver you may have to
press ENTER after having pressed the NUMBER keys.
NOTES:
●
Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
●
It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
●
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
●
It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
1
2
3
456
7
8
0
9
3
¶
4¢
78
1¡
ENTER
CABLE/DBS
POWER
NUMBER
CH
STOP
MBR SET
(Ex.) To set remote control to RCA (DSS):
0 AUX
8 DAILY
7
STOP
MBR SET
CABLE/DBS
Press in succession
Hold
down
Release
DBS BRAND NAME BRAND CODE
JVC (DISH Network) 91
ECHOSTAR (DISH Network) 91
PRIMESTAR 90
SONY (DSS) 81
RCA (DSS) 80