JVC HR-S9400U VCR User Manual


 
EN 39
The VCR's TimeScan indicator lights during TimeScan.
The speed is shown in the upper right corner of the TV screen for approx. 5 seconds.
The TimeScan search speed is the same for SP and EP recordings.
To resume normal playback, press PLAY.
When using the VCR's TIME SCAN SHUTTLE ring, the playback speed may not change depending on how far it is turned.
When using the VCR's TIME SCAN SHUTTLE ring, the playback speed will change up to 7x and -7x search speeds. Turning
the TIME SCAN SHUTTLE ring further will not increase the search speed.
Picture may be distorted at the position where the recording speed is switched.
The picture may be noisy for a moment when you change the playback speed.
During high-speed search with a tape containing both SP and EP recordings, where the recording tape speed switches from EP
to SP, the search speed will change automatically to 7x normal playback speed with TimeScan.
Depending on the tape in use, noise may appear or the upper part of the picture may be distorted.
Picture may appear distorted in comparison to normal playback.
In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Speed
Names of
special-effects
playback
Audio output
* Still mode cannot be engaged using the remote control's TIME SCAN button.
VCR's Time
Scan shuttle
indicator
TimeScan
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x
SEARCH SLOW 6 SLOW SEARCH
Green Orange Red Orange Green
Audio is output. Audio is not output. Audio is output.
Skip Search
SKIP OVER UNWANTED
SECTIONS
1
Press SKIP SEARCH 1 to 4 times during playback, with
"CA PLAYBACK" set to "OFF" ( pg. 37). Each
press initiates a 30-second period of fast-motion
playback. Normal playback resumes automatically.
NOTE:
To return to normal playback during a Skip Search,
press PLAY.
SKIP SEARCH
If you don't want to hear TimeScan audio, set "TIMESCAN AUDIO" to "OFF" (
pg. 40).