Filter
Top Products
EN 63
Control Two JVC VCRs
The supplied remote control is capable of controlling two JVC
VCRs independently using the A/B CODE switch. You can set this
VCR so it responds to remote commands only when the switch is
set to B, and another VCR so it responds to commands when the
switch is set to A. The switch is preset to A because this VCR
normally responds to A-code signals. Follow steps 1 – 4 to set this
VCR to respond to B-code commands.
12
45
3
6
8
0
7
9
POWER
A/B CODE
Child Lock
This feature allows you to prevent the operation of the VCR.
TURN VCR POWER ON
1
Press POWER.
ENGAGE CHILD LOCK
2
Press and hold POWER on the remote control until the
Child Lock indicator ("—") appears on the front display
panel.
● Power turns OFF and the VCR cannot be turned on
from the POWER button on the front panel.
● To cancel Child Lock, press and hold POWER on the
remote to turn the VCR on. During timer recording,
pressing TIMER also cancels Child Lock.
NOTES:
●
When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
●
Timer recording of programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.
TIMER
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET A/B CODE SWITCH
2
Set the A/B CODE switch on the remote control to B.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except setting the A/B CODE
switch to A instead of B in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.