Filter
Top Products
46 EN
VCR Plus+
Timer
Programming
● Before VCR Plus+ Timer programming, see "VCR Plus+
Setup" on page 20.
● Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
Timer recording allows you to program the VCR to
automatically record a program which will be broadcast at
some future time.
The timer record function can be programmed using VCR Plus+
or On-Screen Timer Programming. (੬ pg. 48)
During VCR Plus+ and on-screen programming, the Illumi-
Guide feature tells you which button on the remote control
must be pressed next by lighting the relevant buttons. The
Illumi-Guide feature is activated by the ILLUMI GUIDE button
on the remote control. The Illumi-Guide feature is only active
when the remote control's TV/CABLE/DBS/VCR switch is set to
"VCR". (Illumi-Guide is an optional help feature which makes
programming easier. It is not necessary to use Illumi-Guide to
program the VCR.)
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
● If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
12
45
3
6
8
0
7
9
OK
NUMBER
CANCEL
ILLUMI GUIDE
TIMER RECORDING (cont.)
MENU
LOAD A CASSETTE
1
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
ACCESS VCR PLUS+ SCREEN
2
To use the Illumi-Guide
feature press ILLUMI
GUIDE. The MENU, REW,
PLAY and FF buttons will
light.
Press MENU on the remote
control.
● The clock must be set in
order to access the VCR Plus+ screen. If you haven’t
set the clock, the Main Menu screen appears when
you press MENU. Refer to page 8 for the Advanced
Auto Clock Set procedure or page 9 for the clock
setting procedure.
● If you are using a PRIMESTAR DBS receiver, you may
not be able to access the VCR PLUS+ screen. When
this happens, set "DBS RECEIVER OUTPUT" to "OFF"
(੬ pg.24), then press MENU on the remote control.
● If you are using the Illumi-Guide feature, the following
buttons will light up: NUMBER keys (0 – 9), CANCEL
and MENU.
ENTER PLUSCODE NUMBER
3
Press the appropriate NUMBER keys to enter the
PlusCode number printed in the TV listings for the TV
program you wish to record.
● To make corrections, press CANCEL and input the
correct PlusCode number.
● If the PlusCode number you input is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the PlusCode number is
for a program which has already passed. "ERROR" is
displayed for about 4 seconds and the VCR Plus+
screen reappears (step 2).
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), CANCEL and MENU.
TV/CABLE/DBS/VCR
8
VCR PLUS+
PRESS NUMBER KEY(0-9)
PRESS (MENU) TO MAIN MENU