Filter
Top Products
64 EN
INFORMATION ON J TERMINAL
J Terminal (JLIP(Joint Level
Interface Protocol) Connector)
The J Terminal is used to connect the VCR to a personal
computer or similar device to allow computerized control of the
VCR during editing and certain other operations.
For further details consult your nearest JVC dealer. Information
is also available at one of JVC's World Wide Web sites at http://
www.jvc-victor.co.jp/
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
JLIP ID Number
Your VCR has its own JLIP ID number. This ID number must be
unique when your VCR is connected to another device via its J
terminal. The ID Number is preset to "1" at the factory. You can
change this number to any number between "1" and "99".
If it is necessary to change the JLIP ID number perform the
following steps.
12
45
3
6
8
0
7
9
8
OK
NUMBER
MENU
CH
OK
CH
TIME SCAN
MENU
J terminal
ACCESS MAIN MENU
SCREEN
1
Press MENU as many times as necessary.
ACCESS FUNCTION SET 3
SCREEN
2
Press CH
5
∞ or TIME SCAN
5
∞ to place the arrow next
to "FUNCTION SET 3", then press OK.
ACCESS JLIP ID NO. SET
SCREEN
3
Press CH
5
∞ or TIME
SCAN
5
∞ to place the
arrow next to "JLIP ID NO.
SET", then press OK.
SET JLIP ID NUMBER
4
Press NUMBER key to
enter the desired ID
number, then press OK.
RETURN TO NORMAL
SCREEN
5
Press MENU as many times as necessary.
FUNCTION 3
OVERRIDE
AUTO CLOCK SET
LANGUAGE SELECT
VCR PLUS+ SET-UP
DBS RECEIVER OUTPUT
DBS RECEIVER BRAND SET
=JLIP ID NO. SET
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
JLIP ID NO. SET
1
PRESS NUMBER KEY (O-9)
THEN (OK)
PRESS (MENU) TO END
NOTE:
This VCR may not accept commands from your personal
computer such as:
•
Power ON/OFF while the VCR is in the Timer mode.
•
Power ON when there is no cassette inserted in the VCR.