Filter
Top Products
Masterpage:Right-No-Heading
EN 29
Filename [XV38ASAG_057S-VHS.fm]
Page 29 December 8, 2004 3:22 pm
Express Timer
Programming
If you do not know the G-CODE number for the programme you
wish to record, use the following procedure to set your unit to
timer-record the programme.
Example: To timer-record the programme from 21:00 to
22:00 on 25th December, on channel 1.
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Access the G-CODE/SHOWVIEW screen.
Press PROG.
C
Access the Programme screen.
D
Enter the programme start time.
E
Enter the programme stop time.
Press STOP +/– to enter the time you want recording to
stop.
● Press and hold STOP +/– to move in 30-minute increments, or
press and release repeatedly to move 1 minute at a time.
F
Enter the programme date.
Press DATE +/–.
● The current date appears on the TV screen. The date you enter
appears in its place.
G
Enter the channel position.
H
Set the tape speed.
Press p (SP/LP or EP*).
* EP is for NTSC only.
I
Return to the normal screen.
Press PROG or ENTER. “PROGRAM COMPLETED”
appears on the TV screen for about 5 seconds, then the
normal screen appears.
● If “PROGRAM OVERLAPPED” appears on the screen, see
page 28.
● Repeat steps B – I for each additional programme.
J
Engage the unit’s timer mode.
Press #. The unit turns off automatically and “#”
appears on the front display panel.
● To disengage the timer mode, press # again.
Before performing Express Timer Programming:
● Make sure that the unit’s built-in clock is set properly.
● Insert a cassette with the safety tab in place. The unit will
come on automatically.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/VCR/DVD switch on the remote control to the
right.
● Select the appropriate colour system with “PAL/
MESECAM” and “NTSC” (
੬ pg. 54).
Press START +/–. (If you’re
just starting out, “P1”
appears.)
Slide to the
right.
Press START +/– to enter the
time you want recording to
start.
● Press and hold START +/– to
move in 30-minute
increments, or press and
release repeatedly to move 1
minute at a time.
Press PR +/–.
XV38ASAG_EN_BOOK.book Page 29 Wednesday, December 8, 2004 4:00 PM