JVC HR-XV38SAG DVD Player User Manual


 
Masterpage:Right0
EN 9
Filename [XV38ASAG_04Index.fm]
Page 9 December 8, 2004 3:54 pm
INSTALLING YOUR NEW UNIT
Basic Connections
It’s essential that your unit be properly connected.
A
Check the contents.
Make sure the package contains all of the accessories
listed in “SPECIFICATIONS” on page 70.
B
Situate the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV’s aerial connector.
AV Connection
8To connect to a TV with AV input connectors —
If your TV is equipped with a AV input connectors,
perform AV connection to improve picture quality during
tape playback.
A Connect the aerial, unit and TV as per “RF
Connection.”
B Connect an optional AV cable between the AUDIO/
VIDEO OUT connectors on the rear panel of the unit
and the TV’s AV input connectors.
D
Connect the unit to mains.
Plug the end of the mains power cord into a mains outlet.
DVD
INPUT
(L-1)
AUDIO
VIDEO
OUTPUT
AUDIO
VIDEO
OUTPUT
DVD
AUDIO
S VIDEO
COMPONENT
VIDEO OUT
P
B
P
R
Y
DVD/VCR
AUDIO/VIDEO OUTPUT
ANTENNA IN
ANTENNA OUT
TV aerial cable
To aerial terminal
(provided)
Mains power cord
Mains outlet
Back of unit
TV
To AV input
connectors
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
After the connection is completed, perform Video
Channel Set on page 13.
XV38ASAG_EN_BOOK.book Page 9 Wednesday, December 8, 2004 4:00 PM