Filter
Top Products
Masterpage:Right-No-Heading
27
Filename [XVS20EK_07S-VHS.fm]
Page 27 March 28, 2003 6:55 pm
Repeat Playback
Your unit can automatically play back the whole tape 100 times
repeatedly.
1
Start playback.
Press
4
.
2
Activate Repeat Playback.
Press
4
and hold for over 5 seconds, then release.
●
The Play indicator (
$
) on the front display panel blinks slowly.
●
After playing back a tape 100 times, the unit stops
automatically.
3
Stop Repeat Playback.
Press
8
at any time.
●
Pressing
4
,
3
,
5
or
9
also stops Repeat Playback.
NOTE:
Repeat playback is not possible with a cassette recorded in EP
mode.
NTSC Playback
Your unit is equipped with NTSC circuitry that can play back
NTSC tapes.
1
Load a cassette.
Insert a cassette recorded in NTSC.
2
Start playback.
Press
4
.
●
“NTSC
]
PAL” appears on the screen for about 5 seconds.
NOTES:
●
Some TVs shrink the picture vertically and place black bars at
the top and bottom of the screen. This is not a malfunction on
the part of either the unit or the TV.
●
The picture may roll up and down. This can be corrected using
the V-HOLD control found on some TVs. (This cannot be
corrected if the TV does not have a V-HOLD control.)
●
The counter and tape remaining time readings will be
incorrect.
●
During search, still, or frame-by-frame playback, the picture
will be distorted, and there may be a loss of colour.
●
Depending on the type of TV, the top and bottom portions of
superimposed displays may be cut off during NTSC playback.
Manual Tracking
Your unit is equipped with automatic tracking control. During
playback, you can override this and adjust the tracking manually
by pressing the
PR
buttons.
1
Override automatic tracking.
During playback, press
p
on the remote control.
2
Adjust the tracking manually.
Press
PR +
or
–
on the remote control.
●
Press
p
again to return to automatic tracking.
NOTE:
When a new tape is inserted, the unit enters the automatic
tracking mode automatically.
Soundtrack Selection
Your unit is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing
A.MONITOR
changes the soundtrack as follows:
NOTES:
●
“HIFI L
jh
R” should normally be selected. In this mode,
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
●
For instructions on recording stereo and bilingual
programmes, refer to page 30.
●
“O.S.D.” must be set to “ON” or the on-screen displays will
not appear. (
੬
pg. 72)
TRACK
USE
On-Screen Display
HI FI
L
j
h
R For Hi-Fi stereo tapes
HI FI
L
j
For main audio of Bilingual tapes
HI FI
h
R For sub audio of Bilingual tapes
NORM
For audio-dubbed tapes
HI FI
NORM
For audio-dubbed tapes
XVS20EK_01.book Page 27 Friday, March 28, 2003 7:00 PM