Filename [XVS20EK_09Editing.fm]
Masterpage:Left0
66
Page 66 March 28, 2003 6:55 pm
REMOTE CONTROL
Remote Control
Functions
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the remote control
Keep pressing
S-VHS
down during steps
A
–
B
.
A
Change the remote control code.
Press the
number key “1”
for A,
“2”
for B,
“3”
for C or
“4”
for D.
B
Set the remote control code.
Press
OK
to set the code.
On the unit
C
Turn off the unit.
Press
1
.
D
Display the code.
Press
4
on the unit for over 5 seconds while the unit is
turned off. The code currently set appears on the front
display panel.
●
If the code displayed on the front display panel is different
from the code set on the remote control, go to step
E
.
E
Change the unit’s code.
Press
8
on the remote control. The code currently set on
the remote control will be applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (
੬
pg. 73), it is
impossible to change the remote code.
Before performing the following steps:
Slide the
TV/S-VHS/DVD
switch to the right.
XVS20EK_01.book Page 66 Friday, March 28, 2003 7:00 PM
