Filter
Top Products
14
XV-D701BK [B, E] EN
LET0141-003A
Getting started
To connect to an amplifier/receiver equipped with 5.1-channel inputs
The Dolby Digital decoder and MPEG Multichannel decoder are built in the unit, so you can enjoy the Dolby digital
and MPEG Multichannel surround sound without the need of an external decoder.
Connect the unit’s 5.1-channel outputs to the 5.1-channel inputs of an amplifier or receiver using the supplied audio
cables.
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on
units.
• An Audio/video cable is recommended for connection to the FRONT terminal (Yellow jack (for Video Signal) is not
used in this connection).
NOTE
¶
When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display
to "OFF" and select "5.1 CHANNEL" or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is
selected, you can control the audio output balance of the speakers (see pages 55 and 57).
LEFT
FRONT REAR CENTER
SUBWOOFER
PCM/STREAM
COAXIALOPTICAL
RIGHT
ANALOG
AUDIO OUT
DIGITAL
VIDEO S-VIDEO
AV
VIDEO OUT
AV OUT
COMP.Y/C
AUDIO IN
REAR
RIGHT
RIGHT
FRONT
LEFT
LEFT
CENTER
SUBWOOFER
Audio cable (supplied)
The unit
Amplifier or receiver
White
Red
White
Red
White
Red
White
Red
Audio cable (supplied)
Audio/video cable (supplied)
White
Red
White
Red
Yellow
Yellow