Filter
Top Products
Filename [SR-V10E1-EN.fm]
Masterpage:Left
10 EN
Page 10 September 11, 2002 11:43 am
INSTALLING YOUR NEW RECORDER
Basic Connections
It’s essential that your video recorder be properly
connected.
A
Check the contents.
Make sure the package contains all of the accessories
listed in “SPECIFICATIONS” on page 63.
B
Situate the recorder.
Place the recorder on a stable, horizontal surface.
C
Connect the recorder to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO audio/video input
connectors . . .
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANT. IN connector
on the rear panel of the recorder.
C Connect the provided RF cable between the RF OUT
connector on the rear panel of the recorder and the
TV’s aerial connector.
AV Connection
8To connect to a TV with audio/video input
connectors . . .
A Connect the aerial, recorder and TV as per “RF
Connection”.
B Connect the provided audio/video cable between the
AUDIO/VIDEO OUT connectors on the rear panel of
the recorder and the TV’s audio/video input
connectors.
D
Connect the recorder to mains.
Plug the end of the mains power cord into a mains outlet.
Make AV connection if your TV has audio/video input
connectors in order to reduce the possibility of
interference. With AV connection, you can enjoy
stereo playback of video tapes if you are using a stereo
TV.
NOTES:
● For switching the TV’s mode, refer to the instruction
manual of your television.
● To obtain high-quality S-VHS pictures, you can also use the
S-VIDEO connection described on page 11.
Aerial connector
Back of TV
Audio/video input
connectors
TV aerial
cable
RF cable
(provided)
Audio/video cable
(provided)
Mains power cord
Mains outlet
Back of recorder
AUDIO/VIDEO OUT
ANT. IN
RF OUT
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
After the connection is completed, perform “Auto Set
Up” on page 12.
SR-V10E1-EN.fm Page 10 Wednesday, September 11, 2002 11:43 AM