Filter
Top Products
Filename [SR-V10E4-EN.fm]
Masterpage:Left
52
EN
Page 52 August 8, 2002 5:41 pm
SUBSIDIARY SETTINGS (cont.)
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
੬
pg. 12) or Auto Channel Set (
੬
pg. 50).
A
Access the Main Menu screen.
Press
MENU
.
B
Access the Confirmation screen.
Press
rt
to move the highlight bar (pointer) to
“MANUAL CH SET”, then press
OK
or
e
. The
Confirmation screen appears.
C
Select the channel position.
D
Select the band.
E
Input the channel.
Press the
number keys
to input the channel number you
want to store.
● Input “0” before any single number entries.
● To input the registered station name (ID –
੬
pg. 55), press
e
until “– – – –” (ID setting) begins blinking, then press
rt
.
● For fine tuning adjustment, press
e
until “+/–” begins blinking,
then press
rt
. While tuning, “+” or “–” appears.
F
Enter new channel information.
Press
OK
and the Confirmation screen appears.
● Repeat steps
3
–
6
as necessary.
G
Close the Confirmation screen.
Press
MENU
.
● To change positions, see “Change Station Channel Position”
(
੬
pg. 53).
● If you wish to set station names other than the ones registered
in your recorder, see “Set Stations (B)” (
੬
pg. 54).
Press
rt
w
e
until an open
position in which you want to
store a channel begins
blinking, then press
OK
. The
Manual Channel Set screen
appears.
(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Press
rt
to change the band
between CH (regular) and CC
(cable), then press
e
.
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer programming
with the S
HOW
V
IEW
system in this state, the “GUIDE PROG
SET” screen appears; set the Guide Program numbers on this
screen. (
੬
pg. 29, “ATTENTION — Guide Program Number
Set”)
Or perform “Guide Program Number Set” (
੬
pg. 49).
SR-V10E1-EN.book Page 52 Monday, August 19, 2002 10:20 AM