JVC SR-V10E VCR User Manual


 
Masterpage:Right-NoTitle0
EN
9
Filename [SR-V10E1-EN.fm]
Page 9 August 19, 2002 10:11 am
Buttons with a small dot on the left side of the name can also be used to operate your JVC TV while holding down the
TV
button.
(
“Operating JVC TVs” below)
This remote control transmits A code signals only; it is not applicable to B code signals.
How To Use
The remote control can operate most of your video recorder’s functions, as well as basic functions of JVC TV sets. (
“Operating
JVC TVs” below)
Point the remote control toward the receiving window.
The maximum operating distance of the remote control is about 8 m.
Operating JVC TVs
To operate your TV, while holding down the
TV
button, press the corresponding button:
1
,
TV/VCR
,
TV PR
+/–
,
TV
%
+/–
,
^
(TV Muting).
NOTES:
When inserting the batteries, be sure to insert in the correct directions as indicated under the battery cover.
Depending on the type of JVC TV, some or all functions may not be operated using the remote control.
If the remote control doesn’t work properly, remove its batteries, wait a short time, replace the batteries and then try again.
SR-V10E1-EN.book Page 9 Monday, August 19, 2002 10:20 AM