JVC SR-V10E VCR User Manual


 
Masterpage:Right-Full-NoTitle0
EN
45
Filename [SR-V10E4-EN.fm]
Page 45 August 8, 2002 5:41 pm
* The default setting is
bold
in the table below.
8
DIGITAL TBC/NR
ON
OFF
Your recorder is equipped with the Digital TBC (Time Base Corrector) that removes
jitter from fluctuating video signals to deliver a stable picture even with old tapes and
rental cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise and enables clear
picture reproduction is also linked to this function.
We recommend that you set “DIGITAL TBC/NR” to “ON” when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the source player for editing.
NOTES:
If you play back a tape recorded under poor TV reception condition, the picture may become
more stable with Digital TBC/NR set to off.
When “DIGITAL TBC/NR” is set to “ON”, if you play back a tape where certain types of signals
are recorded (using a PC or some character generators), the playback picture may be distorted.
If this is the case, set “DIGITAL TBC/NR” to “OFF”.
When playing back a MESECAM tape, Digital TBC/NR does not function even though “DIGITAL
TBC/NR” is set to “ON”.
8
B.E.S.T.
ON
OFF
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to “ON” or
“OFF” (
pg. 23).
8
PICTURE CONTROL
AUTO
EDIT
SOFT
SHARP
This feature helps you to adjust the playback picture quality according to your
preference. Normally select “AUTO”.
AUTO
: Provides the optimised picture benefits of the B.E.S.T. Picture System.
EDIT
: Minimizes picture degradation during editing (recording and playback).
SOFT
: Reduces image coarseness when viewing overplayed tapes containing a lot
of noise.
SHARP
: Clearer, sharper-edged picture when viewing images with lots of flat,
same-coloured surfaces such as cartoons.
NOTES:
When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you
select another mode.
When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish dubbing the
tapes.
When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO” to
“NORM”.
8
AUTO TIMER
ON
OFF
When this function is set to “ON”, the timer is automatically engaged when the
recorder power is turned off, and automatically disengaged when the recorder is
powered back on.
NOTE:
For safety, when “AUTO TIMER” is set to “OFF”, all other recorder functions are disabled while
the Timer mode is engaged. To disengage the timer, press
#
(TIMER).
8
O.S.D. (REC)
ON
OFF
When this function is set to “ON”, all the indicators displayed on the TV screen will be
recorded. If you do not want to record the indicators, select “OFF”.
SR-V10E1-EN.book Page 45 Monday, August 19, 2002 10:20 AM