Filter
Top Products
Masterpage:Right
EN 27
Filename [SR-V10E1b-EN.fm]
Page 27 September 11, 2002 11:48 am
Using two sets of SR-V10E, a long recording will be possible
(such as camcorder recording, another recorder playback or TV
broadcast).
NOTE:
Use the buttons and controls on the recorder for the Series
Recording operations (except when using Mode Lock
(
੬ pg. 20)).
A
Make connections.
Connect two sets of SR-V10E to other device, antenna or
cable as illustrated on page 26.
● The mini-plug cable is a mono 3.5 mm mini-plug to mono 3.5
mm mini-plug connector.
● When connecting a camcorder or another recorder with an
S-VIDEO output connector as recording deck, it is
recommended to use the S-VIDEO connection to obtain the
high quality pictures.
B
Turn on all components.
After completing the connections, turn on all the
components.
● Set your TV to the VIDEO or AV mode. Refer to the TV
instruction manual.
C
Set the input mode on both SR-V10E.
Turn the JOG dial to the right or left on each SR-V10E to
select the appropriate input mode depending on the
connectors being used.
“L-1”: for the rear AUDIO/VIDEO IN connectors
“F-1”: for the front AUDIO/VIDEO input connectors
“S-1”: for the rear AUDIO/S VIDEO IN connectors
“S-2”: for the front AUDIO/S-VIDEO input connectors
D
Prepare for recording.
Insert the recording cassette into each SR-V10E and
prepare the playback source device.
E
Start recording.
Press 7 on either of SR-V10E.
● When the tape remaining time reaches to 2 minutes during
recording, the other SR-V10E successively starts recording.
(The cassette will automatically be rewound when the
recording stops.*) Therefore, recording will be continued onto
cassettes loaded on two SR-V10E alternately.
* Replace the cassette after rewound if you want to continue to record
onto another cassette.
F
Stop recording.
Press 0 on the SR-V10E which is recording.
NOTES:
● When recording a TV broadcast, select in the same channel
on both SR-V10E.
● If the playback source device has a superimpose/OSD disable
feature, set its superimpose or display feature to “OFF“.
● If you do not want to record the operational indicators
displayed on the TV screen during recording, set “O.S.D.
(PLAY)“ and “O.S.D. (REC)“ to “OFF“ (
੬ pg. 45, 46).
● If there is a power outage during Series Recording, the
recording will resume automatically when the power is
restored to the recorder if the lithium battery is not exhausted.
● It is possible to use the Mode Lock function (
੬ pg. 20).
SR-V10E1b-EN.fm Page 27 Wednesday, September 11, 2002 11:48 AM