Filter
Top Products
Masterpage:Right-NoTitle0
EN 29
Filename [SR-V10E2-EN.fm]
Page 29 September 3, 2002 10:34 am
D
Set the tape speed.
Press SP/LP/EP (p).
● It is not possible to select EP mode if “COLOUR SYSTEM” is
set to “MESECAM”
. (੬ pg. 48)
E
Set the VPS/PDC mode.
Press VPS/PDC (number key “7”) to select “ON” or
“OFF”.
● If “VPS/PDC ON” is displayed on the TV screen, VPS/PDC is
set to ON.
● If “VPS/PDC OFF” is displayed on the TV screen, VPS/PDC is
set to OFF.
੬ “VPS/PDC Recording” on page 31.
F
Access the Title Edit screen.
G
Enter the programme title.
H
Return to the normal screen.
Press PROG or OK. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen and “Err” on the front display panel, see
page 34.
● Repeat steps 1 – 8 for each additional programme.
I
Engage the recorder’s timer mode.
Press # (TIMER). The recorder turns off automatically and
“
#” appears on the front display panel.
● To disengage the timer mode, press # (TIMER) again.
NOTES:
● To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (number key
“9”) for weekly serials or DAILY (number key “8”) for daily
serials (Sunday — Saturday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬ pg. 33).
● Even if a power failure occurs, the recorder keeps your timer
programmes if the lithium battery is not exhausted.
Press the number key “1”.
The Title Edit screen appears.
● You can access the Title Edit
screen only when “PROG.
NAVIGATION” is set to “ON”.
(
੬ pg. 46)
Press the number keys and e
to enter characters, then
press OK. For details, refer to
“Entering Character” on
page 39.
Satellite Receiver Users
To timer-record a satellite broadcast using the SHOWVIEW
system:
A Set the Guide Program numbers for all satellite broadcasts
received on your satellite receiver. (
੬ pg. 49)
B Perform steps 1 – 9.
C Set the satellite receiver to the appropriate channel before
the selected programme begins.
D Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“GUIDE PROG SET” appears after performing step 3 if the
Guide Program number for the S
HOWVIEW number you
entered has not been set.
● Press the number keys or
rt to input the channel
position number on which your recorder receives that
station, then press OK or
e to set the Guide Program
number. The S
HOWVIEW Program screen appears.
(Example)
To timer-record a ZDF
programme with the
S
HOWVIEW system.
* If your recorder receives ZDF on
the channel position 2, press OK
or
e after entering “2”.
SR-V10E2-EN.fm Page 29 Tuesday, September 3, 2002 10:34 AM