JVC SR-V10E VCR User Manual


 
Filename [SR-V10E2-EN.fm]
Masterpage:Left
30 EN
Page 30 September 3, 2002 1:07 pm
TIMER RECORDING (cont.)
Express Timer
Programming
If you do not know the SHOWVIEW number for the programme
you wish to record, use the following procedure to set your
recorder to timer-record the programme.
Example: To timer-record the programme from 21:00 to
22:00 on 25th December, on channel 1.
A
Access the SHOWVIEW screen.
Press PROG.
B
Access the Programme screen.
The front display panel looks like this:
C
Enter the programme start time.
The front display panel looks like this:
D
Enter the programme stop time.
Press STOP+/– to enter the time you want recording to
stop.
Press and hold STOP+/– to move in 30-minute increments, or
press and release repeatedly to move 1 minute at a time.
E
Enter the programme date.
Press DATE+/–.
The current date appears on the TV screen. The date you enter
appears in its place.
Before performing Express Timer Programming:
Make sure that the recorder’s built-in clock is set properly.
Insert a cassette with the safety tab in place. If the tab has
been removed, set “REC SAFETY” to “OFF” (
pg. 48).
The recorder will come on automatically.
Turn on the TV and select the video channel (or AV mode).
ATTENTION
It is impossible to perform timer programming during
recording.
Press START+/–. (If you’re
just starting out, “P1”
appears.)
Press START+/– to enter the
time you want recording to
start.
Press and hold START+/– to
move in 30-minute
increments, or press and
release repeatedly to move 1
minute at a time.
SR-V10E2-EN.fm Page 30 Tuesday, September 3, 2002 1:08 PM