Filter
Top Products
44
5.3 CLOCK / TIMER
The DVR provides a weekly table, consisting of two periods of time each day for scheduled
recording. This option allows you to set the time each day that the DVR will start and stop recording.
CLOCK:
This entry allows users to set the system time.
NOTE: Clock data is retained for about 3 months after the 15-hour power supply is used up
(Operate On mode).
REC ENABLE:
This option enables/disables the programmed scheduled recording.
ON: Enables the scheduled recording.
OFF: Disables the scheduled recording.
TIMER:
This entry allows users to program the time each day that the DVR will start and stop recording. There
are two time periods each day available for scheduling. The time is displayed in a 24-hour clock format.
If there is a time overlapping showing between two continual time period settings, the device will
automatically combine the two time-period settings into one combined time-period setting.
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO TIMER PAGE
CLOCK / TIMER
CLOCK : SET
REC ENABLE : OFF
TIMER : SET
MAIN PAGE
TIMER REC ENABLE
REC SCHEDULE
START END START END
S :06:00-16:00 12:00-18:00
REC SCHEDULE
START END START END
S :06:00-18:00 00:00-00:00
45
5.4 COMMUNICATION
This option allows you to configure the status of the RS-232 communication port when connected to an
external device, and the Ethernet communications settings. (Please refer to the RS-232 Protocol and
Network Function for more details)
COMM ID:
Communication ID for RS-232 and RS-485 communication. After the VR-601
receives a RS-232 or
RS-485 command, it checks if the <Dest ID> within the code is the same as the COMM ID, in which case
the particular command can be accept.
RS-232:
The RS-232 communication port can be either in an importing or exporting mode according to your
applications.
ON: Enables the RS-232 communication port. When you wish the unit to be controlled by an
external device, please select this entry for use.
OFF: Disables the RS-232 communication port.
RS-485:
The RS-485 communication port can be either in an importing or exporting mode according to your
applications.
ON: Enables the RS-485 communication port. When you wish the unit to be controlled by an
external device, please select this entry for use.
OFF: Disables the RS-485 communication port.
NET ENABLE:
This option selects either enable or disable for the Ethernet communication port.
OFF: Disables it.
ON: Enables it.
MAIN MENU
RECORD
ALARM
CLOCK / TIMER
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
COMM ID : 01
RS232 : ON
RS485 : ON
NET ENABLE : OFF
NET DHCP : OFF
NET IP : SET
FTP SETTING
MAIN PAGE
SET RS232 / RS485 ID