Filter
Top Products
30
Perform channel scan
Use the
buttons to select (yes or no) whether you wish to start a channel scan. It is not essential
to start a channel scan; instead you can use the factory pre-programmed channels. However the channels
do change from time to time (e.g. their frequencies change), which the receiver does not automatically
detect, and can then be found only by performing a channel scan.
If you selected “No”, you can press the
!
(green) button to skip directly to the next item of the fi rst
installation.
If you selected “Yes”, you can press the
button to progress to the next selection item.
Channel scan mode
Use the
buttons to select whether you wish to scan “free & scrambled”, “only free” or “only
scrambled” channels.
To view encrypted channels you need the appropriate CA (Conditional Access) module and a
valid smart card together with a valid subscription to a Pay-TV provider.
Press the
button to move to the next selection item.
Network scan
If you set the network search to “Off”, only the factory stored transponders of the satellites you previously
selected will be scanned for new and as yet unlisted channels.
If you set the network scan to “On”, the transponder network enables additional transponders that have
not yet been stored to be located. They are then stored and scanned for new channels in the same
way as the existing transponders.
Press the
!
(green) button to start the channel scan, or if you set channel scan to “Off” you are guided
straight to the next item in the fi rst installation process.
When the scan has been completed, you will see the following message (example):
FIRST INSTALLATION