Filter
Top Products
60
Satellite
Select the satellite to be scanned, using the
buttons. Make sure your reception system is aligned
to the selected satellite. You can scan only one satellite at a time. If you have connected a multi-feed
reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this
procedure once for each satellite. You can however start the fi rst installation again, in the course of which
a channel scan of all the satellites you selected is performed.
Press the
button to move to the next selection item.
Channel scan mode
Use the
buttons to select whether you wish to scan “free & scrambled”, “only free” or “only
scrambled” channels.
To view encrypted channels you need the appropriate CA (Conditional Access) module and a
valid smart card together with a valid subscription to the respective Pay-TV provider.
Press the
button to move to the next selection item.
Network scan
Use the
buttons (On/Off) to select whether a network scan should be performed. If you set the
network scan to “Off”, only the factory stored transponders of the satellites you previously selected
will be scanned for new as yet unlisted channels.
If you set the network scan to “On”, the transponder network enables additional transponders that have
not yet been stored to be located. They are then stored and scanned for new channels in the same way
as the existing transponders.
When you have made your settings, use the
buttons to select “Start Search” and press the
button
to start scanning. You can cancel the scan at any time by pressing the
button. During the scan you
will see the following message (example):
TV channels found
Radio channels
found
Progression bar
Satellite with the
transponder
currently being
scanned
CHANNEL SEARCH (CHANNEL SCAN)