Filter
Top Products
9
Connection of Equipment
Chapter 1: Connection of Equipment
Before Start
Do not insert the power cord plugs of the player and the
connected components until all of the components have
been connected.
Be sure to insert all connection cables securely. If a cable
is plugged incompletely, lack of video, lack of audio or
noise may result.
Before connecting or disconnecting a connection cord,
be sure to unplug the power plug from the wall power
outlet. If a connection cable is connected or disconnected
while the power plug is left connected, malfunction or
equipment damage may result.
When a DVD AUDIO disc is played, the player can output
audio signals at very high frequencies. As this may
sometimes lead to speaker damage due to a high-volume
sound, do not set "Audio Filter" to "Filter 110 kHz" when
the speakers in use are not suitable for high-frequency
reproduction. Œ
Also, be sure to check the actual sound level when
increasing or decreasing the volume control setting.
Remote control range:
¶ When the controllable distance of the joystick remote
reduces, replace both batteries with new ones.
¶ Do not install the player in a place where the remote
control sensor is subjected to direct sunlight or the
light of a fluorescent lamp base on high-frequency
lighting (inverter system, etc.). Otherwise, the control
range of the joystick remote will be reduced.
If the joystick remote is used
outside this area, correct operations
will not be possible.
Preparation of Remote Control
Unit
Installing the batteries:
Open the cover and insert the batteries (R6/AA) by
observing the polarity marking.
\