Filter
Top Products
Krell DVD Standard 25
Krell recommends using balanced interconnect cables. Balanced
interconnect cables not only can minimize sonic loss but are also
less sensitive to induced noise, especially with installations using
long cables. Balanced connections have 6 dB more gain than single-
ended connections. When level matching is critical, keep this gain
value in mind.
This section provides information about connecting your DVD
Standard to other components in your system. The DVD Standard is
equipped with a variety of connection options, for ease of integration
into your home theater system.
Follow these steps to connect the DVD Standard to your system.
1. Make sure all power sources and components are off before
connecting inputs and outputs.
2. Neatly organize the wiring between the DVD Standard and all
system components. Separate AC wires from audio cables to
prevent hum or other unwanted noises from being introduced into
the system.
3. Connect the input of your video components to the appropriate
output of the DVD Standard. See Getting Started, on page 6, for
information on ensuring that your video monitor and settings are
compatible with the DVD Standard.
4. Connect the balanced or single-ended analog outputs.
5. Plug the AC power cord into the IEC connector (37) on the back
panel, then plug the AC power cord into the wall socket. The red
stand-by LED (3) on the front panel illuminates.
Connecting the DVD Standard
to Your System
USING BALANCED
CONNECTIONS
Connection
Steps