Krell Industries DVD Standard DVD Player User Manual


 
Krell DVD Standard 5
Before you install the DVD Standard into your system, review the
following guidelines to choose the location for the component. This
will facilitate a clean, trouble-free installation. The DVD Standard
does not require any type of special rack or cabinet for installation.
Place the DVD Standard on a firm, level surface, away from exces-
sive heat, humidity, or moisture. The DVD Standard requires at least
two inches (5 cm) of clearance on each side and at least two inches
(5 cm) of clearance above and below the component to provide ade-
quate ventilation. Installations inside cabinetry may need extra venti-
lation.
The DVD Standard has superb regulation and does not require a
dedicated AC circuit. Operate the DVD Standard only with the power
cord supplied.
Avoid connections through extension cords or multiple AC adapters.
High quality 15 amp grounded AC strips are acceptable. High quality
AC line conditioners or filters may be used if they are grounded and
meet or exceed the unit’s power supply rating of 100 VA.
Please contact your Krell dealer, distributor, or Krell before using any
device designed to alter or stabilize the AC power for the DVD
Standard.
Placement
The DVD Standard incorporates an advanced suspension system and does
not require additional mass coupling or isolation. You may experiment with
feet or cones as long as they are not permanently affixed to the unit. Any
unauthorized modifications to the unit or electronics will void the warranty.
Do not attach enhancement accessories such as rings, mats, or
dampers to individual discs. These accessories may interfere with the
disc transport, resulting in erratic playback and/or poor performance.
Note
IMPORTANT
AC Power
Guidelines