Filter
Top Products
26 Krell DVD Standard
Operating Your DVD Standard
On/Off/Stand-by
Krell recommends leaving the DVD Standard in the stand-by mode when
not playing a disc.
Note
This section provides information about operating the DVD Standard.
After the DVD Standard is connected to the video monitor and other
system components, it is ready for operation.
1. Insert the AC power cord into the IEC power connector (37) on
the DVD Standard. Insert the other end into the AC wall recepta-
cle. The red stand-by LED (3) illuminates.
2. Press the power button (1) or key (38) The blue power LED (2)
on the front panel illuminates. The DVD Standard is in the opera-
tional mode. The disc transport is active.
3. To return to the stand-by mode, press the power button or power
key again. The red stand-by LED illuminates.
The DVD Standard can play the following discs:
DVD 12CM single- or double-sided, 1 or 2 layer
DVD 8CM single- or double-sided, 1 or 2 layer
Video CD 12CM single-sided
Video CD 8CM single-sided
CD-DA 12CM single-sided
CD-DA 8CM single-sided
CD-R 12CM single-sided
1. Press the open/close button (13) or key (56) to open the disc
transport (14).
2. Place the disc on the transport.
3. Press the open/close button or key again to close the disc
transport.
4. Playback begins from the first track.
5. Press the stop button (7) or key (57) to end disc playback.
Adjust the volume level through your system volume control.
See Front Panel Description, on page 11, and How to Write a Program,
on page 27, for more information on disc playback options.
How to Play
a Disc
Notes
COMPATIBLE DISCS