Filter
Top Products
TracVision M9 Installation Guide
1
Standard Configuration with Master Control Unit (MCU)
KVH, TracVision, and the unique light-colored dome with contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2007 KVH Industries, Inc., All rights reserved. 54-0418 Rev. C
These instructions explain how to install the TracVision M9 satellite TV antenna system on a
vessel. Complete instructions on how to use the system are provided in the User’s Guide.
Installation Steps
Who Should Install the System?
To ensure a safe and effective installation, KVH recommends that a KVH-authorized marine
technician install the TracVision antenna. KVH-authorized technicians have the tools and
electronics expertise necessary to install the system. To find a technician near you, visit
www.kvh.com/wheretogetservice.
Antenna LNB Types
The installation process differs slightly depending on the type of LNB (low noise block) that is
installed in the antenna (circular or linear). These differences are noted throughout this manual.
Appendix C on page 25 notes the type of LNB required for each region and satellite.
Technical Support
If you need technical assistance, please contact KVH Technical Support:
1. Inspect Parts and Get Tools...3
2. Plan the Antenna Installation...4
3. Plan the MCU Installation...5
4. Prepare the Antenna Site...6
5. Wire the Antenna...7
6. Mount the Antenna...8
7. Remove the Restraints...9
8. Wire the Receiver(s) and MCU...10
9. Connect Power...11
10. Mount the MCU...12
11. Select Satellites...13
12. Calibrate the Internal Sensor...14
13. Educate the Customer...16
North/South America, Australia:
Phone: +1 401 847-3327
E-mail: techs@kvh.com
Europe, Middle East, Asia:
Phone: +45 45 160 180
E-mail: support@kvh.dk