Filter
Top Products
22
6. Attach the supplied cable exit shroud over
the cable access hole inside the baseplate,
using the two M4 screws you removed earlier
from the cover plate (see Figure 41).
Replace the Logo Plate
1. Attach the supplied blank logo plate using six
M4 screws (see Figure 42).
2. Discard the old logo plate, or save it in case
you need to change the cable routing in the
future.
The baseplate conversion process is complete!
Complete the remaining system installation steps
starting with Step 6 on page 7.
Figure 41: Cable Exit Shroud Installed Over Cables
Cable Exit Shroud
M4 Screw (x2)
Figure 42: Blank Logo Plate (No Cable Slots)
M4 Screw (x6)
Blank Logo Plate
Continued...
A