Filter
Top Products
2. Open the terminal emulation software and
establish the following settings:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
3. Apply power to the TracVision LF/SF system and
allow the system to complete full initialization.
Data should be scrolling on the PC display to
identify any system problems detected. If no data
is seen, recheck your connections and the terminal
software setup.
4.5 Maintenance Port Parser
Commands
TracVision LF/SF system parser commands are detailed in
Appendix F.
4-7
Troubleshooting
54-0194 Rev. D