Filter
Top Products
USING LG EZSIGN 3.0 EDITOR
17
Sending via a Wireless Network
Using a wireless network, you can send content
files saved on a PC to the TV without having to
connect a USB device. To use this function, you
must first connect a wireless dongle to the TV in
order to connect to the wireless network. (See the
Network Setting section.) The PC must also be
connected to a router via a wired or wireless
connection.
PC Editor S/W
USB Wi-Fi Dongle
Note
ꔈ The wireless dongle must be connected to the
wireless dongle slot among the USB slots on
the TV.
ꔈ If a content file is sent via the wireless dongle,
the file is immediately saved in the TV memory.
ꔈ The connection may not be established
depending on wireless signal interference or
strength.
NOTE
ꔈ If there is wireless signal interference, check
whether the router is operating normally and
connect it again. When there is a wall or anoth-
er router between the router and the TV it may
not work properly. Remove any obstacles
before installing it.
ꔈ When multiple TVs are connected to a single
router, make sure that the router is working
properly before setting a network.
ꔈ Wi-Fi connection is available only through
an AP.
ꔈ External Internet environments are not supported.
ꔈ New EzSign TV content will always replace
existing content without a notification pop-up
message.
ꔈ A password must be set for the router to
prevent other devices from being connected.
1 Connect a wireless dongle to the TV that you
are connecting to the router. You can check the
network connection status from the TV's network
menu. (The network must be connected to the
minimum gateway.)
- For details on network connections, see page 19.
2 Connect the PC to the router via a wireless/
wired connection.
3 In EzSign 3.0 Editor, select Send via Wireless
Network.
4 Use the Refresh button to automatically scan for
TVs connected to the router. You can also
select Add TV to manually enter the IP address
of a TV.
5 Select a TV you want to connect and then select
Send.
6 When sending is complete, the sent content file
is immediately played on TV.
NOTE
ꔈ The first time the TV is shown on the list it is
identified by its serial number.
You can give it a new name (up to 16 characters)
by clicking the TV name.