Filter
Top Products
BEFORE USING
5
6 When the installation is complete, click Finish.
Note
ꔈ After the installation is complete, the EzSign
service for running Tomcat 7.0 is registered to
the system. It starts automatically upon
Windows start-up.
ꔈ If a firewall is enabled, to use the remote
execution mode and message transmission
function, EzSign 3.0 Editor is added to the
firewall allowed program list.
ꔈ As EzSign 3.0 Editor uses the built-in Chrome
Portable browser, the browser can be used
independently without affecting how the Chrome
browser that was previously installed on the PC
runs, or the browser's settings.
ꔈ If you change the installation path to install the
program under C:\Program Files, the pop-up
message below may appear every time you
start EzSign 3.0.
Mac OS
1
Double-click the LG EzSign 3.0.dmg file.
Note
ꔈ When you install LG EzSign 3.0, always use the
LG EzSign 3.0.dmg file to start the installation.
If not, the installation may not proceed normally.
2 Double-click the LG EzSign 3.0.pkg file in the
LG EzSign 3.0 window.
3 Click Continue in the LG EzSign 3.0 Installation
window.
Note
ꔈ If the program is already installed on the
computer, the installation will terminate.Remove
the previous program and then run installation
again. (Refer to Deleting for how to remove the
previous program.)
ꔈ If Java is not installed on the computer, the
installation will terminate. Install Java and then
run installation again.(Refer to the Mac OS help
about how to install Java.)
ꔈ If the computer's operating system is not
supported by LG EzSign 3.0, the program can
continue to install, but LG EzSign 3.0 may not
function correctly.