Filter
Top Products
Upgrading the software
USB upgrade
You can upgrade the software by using USB Memory Stick.
1
Connect your USB Memory Stick with the upgrade file to the USB
terminal on the side of your TV.
2
Use H I to select Software update, then press OK.
3
Use H I to select USB, then press OK.
4
Use H I to select the desired Update file.
5
Use J K to select Yes, then press OK.
6
Read the on-screen instructions and confirm that you want to
continue with the installation.
upgrade is in progress.
Do not remove the USB storage device or turn the TV off while
Software update is in progress. Please wait.
Updating your TV with new software:
7
When the software upgrade is completed, press B to set the unit
into Standby mode, then remove the USB Memory Stick.
8
Unplug the AC power cord for 5 seconds from the AC outlet and
plug it again.
9
Press B again to Turn the unit On.
●
The TV starts up with the new software.
For further assistance, please contact Call Center.
Network updates
You can update the software by connecting the unit to the Internet.
1
Use H I to select Software update, then press OK.
2
Use H I to select Network, then press OK.
3
Use J K to select Yes, then press OK.
●
This unit will then start checking for the latest FirmWare (software)
version.
4
Confirmation message will appear.
Use J K to select Yes, then press OK.
●
The unit will start downloading the latest FirmWare (software)
version.
●
The unit will start updating the FirmWare (software) version.
●
It may take a while to complete the updating.
5
When the software update is complete, press B to make sure the
unit goes to Standby mode.
6
Unplug the AC power cord for 5 seconds from the AC outlet and
plug it again.
7
Press B again to Turn the unit On.
●
The TV starts up with the new software.
For further assistance, please contact Call Center.
Note(s)
●
In order to update software via the Internet, you must connect the unit to the Internet
and set up necessary settings.
Network settings assistant L p. 35; Network L p. 34
●
Please do not unplug the AC power cord or Ethernet cable while executing the Network
updates.
●
All settings will remain the same even if you update the software version.
●
The version of Net service will also be updated if newer version of Net service is available
when updating the firmware.
●
When you start up the TV or a net service after executing the software update, a message
may appear on the screen prompting for software update again. In this case, please select
Update to start USB update or network update. For further assistance, please contact call
center.
39 .English
Continued on next page.