Marantz MV8300_U1B VCR User Manual


 
38 EN
IN F-1
+
1
POWER
TIMER ( )
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to
24 broadcasts, as far as a year in advance. Remember,
the clock must be set before you can program the timer
( pg. 10).
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
automatically.
2
Access VCR PLUS+ screen
Press PROGRAM.
3
Access Program screen
Press START +/– once.
4
Set program start time
Press START +/–
repeatedly to enter
the time you want
recording to start.
Press and hold
START +/– to
increase the time in
30-minute intervals.
5
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
Press and hold STOP +/– to increase the time in
30-minute intervals.
6
Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
7
Set channel number
Press TV/VCR CH +/–.
If you are using a DBS receiver, see
“ATTENTION FOR DBS RECEIVER USERS” on
next page.
Holding down TV/VCR CH +/– rapidly changes
the channel numbers.
Express Timer
Programing
VCR
TV
CABLE
/DBS
POWER
TIMER ( )
8
9
0
WEEKLY
DAILY
DBS
2
3 - 7
CONFIRM CANCEL
: AM
STD (SP)
/ / ––
8:00 PM
START TIME STOP TIME DATE
DAILY/WEEKLY
CH
SOURCE
TIMER PROGRAM
REC SPEED
SET PROGRAM WITH [+/–, REC SPEED
8=DAILY, 9=WEEKLY] THEN PRESS "CONFIRM"
STARTSTOP DATE CH
EXIT
PROG.
EVERY SUN
Turn on the VCR and the TV, and select the AV
mode on the TV.
Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
HM-DH40000U-EN34-41 1/23/3, 5:22 PM38