Filter
Top Products
EN 59
* The default setting is bold in the table below.
This function allows you to record on VHS tapes with S-VHS picture quality. Tapes
recorded using this function can be played back on a VCR equipped with the S-VHS ET
function. The S-VHS indicator lights up on the front display panel when “S-VHS ET” is set
to “ON”.
NOTES:
●
Before recording, make sure that “V. CALIBRATION” is set to “ON” (
੬
pg. 54).
●
You cannot activate the S-VHS ET function...
– while recording is in progress.
– while timer-recording or Instant Timer Recording (
੬
pg. 28) is in progress.
– while Video Calibration (
੬
pg. 54) is in progress.
●
S-VHS ET does not work with S-VHS tapes.
●
To keep the highest quality recording and playback pictures over a long period of time, S-VHS recording
on S-VHS tapes is recommended.
●
Use of high grade tapes are recommended for S-VHS ET recordings.
On some tapes, picture quality will not improves even if the S-VHS ET function is used. Check the
recording quality before you start important recordings.
●
You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR equipped with SQPB
(S-VHS QUASI PLAYBACK) function. (Notice some VCRs are not compatible with this function.)
●
While playing back a tape recorded with this function on some tapes, noise may appear. (If playback
picture becomes blurred or interrupted, use a cleaning cassette.)
●
During special effect playback (
੬
pg. 31), noise may appear. If special effect playback is performed
frequently on a tape recorded with this function, the tape may be damaged and picture may be
deteriorated.
Ⅵ S-VHS ET
ON
OFF
Ⅵ DISPLAY
ON
OFF
When this function is set to “OFF”, only “:” appears on the front display panel.
NOTE:
Even if you set “DISPLAY” to “OFF”, each item appears on the front display panel in the following
cases;
●
when the timer-recording is in progress/in the timer standby mode (
੬
pg. 34 – 41)
●
in the satellite Auto Recording standby mode (
੬
pg. 62)
●
during Plug & Play setting (
੬
pg. 9)
●
when you press REC (
¶
) twice for the ITR (
੬
pg. 28)
●
when you set the remote control code (
੬
pg. 71)
●
when you press DISPLAY, the current status appears for a few seconds.
HM-DH40000U-EN53-63 1/22/3, 5:45 PM59