Filter
Top Products
User Guide
22
6 Tap the soft or hard button you want to select as a macro.
A message screen appears instructing you that the RC3200 is
now recording the buttons you press as macro steps.
7 Tap Start.
The Home Pages appears with the ‘Recording’ label at the top
of the screen. The buttons you tap on this screen will not be
recorded. From the Home Pages you can go to the different
devices or you can press the Extra hard button to go to the
Extra screen with delays and beeps.
8 Tap the button of the device you want to go to.
The device screen appears.
9 Tap the soft or hard buttons with the commands you want to
record.
10 Press the Page Up and Page Down buttons to go to different
screens of the same device.
-or-
Press the Home button to go to the Home Pages again.
11 To add delays and beeps to the macro, press the Extra hard but-
ton on the Home Pages.
The Extra screen appears.
Delays Use delays to compensate
for the dead time when a
component first powers up
and will not respond to
another IR command.
Additionally, short .5 second
delays make channel
macros more reliable.
Beeps Use beeps to signal that the
macro is finished.
To add a delay or a beep, tap the corresponding button.
TIP By tapping several Delay buttons, the duration of the delay will
be increased.
Setting Up Your RC3200