Filter
Top Products
User Guide
29
RC3200 is not recognized by the RC3200 Setup Programming
Software software
• Make sure the serial cable is properly connected. See ‘RC3200
Setup Programming Software’ on p. 24.
• Disconnect other equipment connected to the serial ports, e.g.
PDA’s.
• Plug the serial cable in another serial port.
• Try to connect multiple times.
Programming Problems
Buttons are not sending the correct commands
• Check whether the button of the device is learned properly.
See ‘Learning Commands’ on p. 15.
• Check whether the macro is recorded properly. See ‘Recording
Macros’ on p. 21.
RC3200 will not switch modes
• Replace the batteries. When the batteries are low RC3200 pre-
vents you from switching to customizing modes so that no cus-
tomization can get lost.
RC3200 is low on memory
• Revert the RC3200. See ‘Revert’ on p. 14.
The configuration file is corrupted
• When this unlikely event occurs, you have to revert to the original-
configuration or use RC3200 Setup Programming Software to
download a new configuration file. All your customized commands
and devices will be lost and you will have to reprogram your
RC3200. If you use RC3200 Setup Programming Software, it is
advised to make backup copies of your customized configurations.
See ‘Revert’ on p. 14 and ‘RC3200 Setup Programming Software’
on p. 24.
RC3200 error message
If the error message ‘Invalid CF version or corrupt Flash!’ occurs:
• Use the Reset button on the back of the RC3200. See ‘How do I
reset the RC3200?’ on p. 27.
• Try to recover the RC3200 Configuration File (NCF) by download-
ing a backup copy or the default file from RC3200 Setup
Programming Software. See ‘RC3200 Setup Programming
Software’ on p. 24.
• Go to the Marantz website http://www.marantz.com for more infor-
mation.
Troubleshooting