Filter
Top Products
User Guide
27
How do I reset the RC3200?
Under normal circumstances, you will never have to reset the
RC3200. However, on rare occasions, if the RC3200’s touch screen
freezes or if you notice unusual behavior, you need to perform a
reset to get the RC3200 running again. All customized commands
and devices are retained.
1 Slide the battery cover off the
back of the RC3200. You will
see the Reset button in the
battery compartment.
2 Use an unfolded paperclip or a sharp pencil to carefully press the
Reset button.
The RC3200 restarts and an Introduction screen appears. The
RC3200 beeps twice to indicate it is ready for use.
How do I revert to the original configuration?
Reverting to the original configuration restores the RC3200’s
devices and commands to its state when you purchased it. This
means that all programming is lost permanently. Normally, you
never have to revert the RC3200. See ‘Revert’ on p. 14.
1 Press and hold the Mode button for 3 seconds.
The Mode Menu appears.
2 Tap the Setup button.
3 Scroll to the third setup page.
4 Tap the Revert button.
A message screen appears to confirm or cancel the revert pro-
cess.
5 Press OK or Cancel.
Do I have to calibrate the touch screen?
The RC3200’s touch screen is calibrated when it leaves the factory.
You only have to re-calibrate when the software is upgraded.
FAQ
Erwin to place
illustration here.