Filter
Top Products
_Important:
_'Important:
_Important:
procedure
(See illustration on the following page.)
0 Connect the incoming cable or antenna to the ANTENNA IN
terminal on the VCR.
O Connect one end of a coaxial cable to the ANTENNA OUT
terminal on the VCR.
Connect the other end of the coaxial cable to the antenna
terminal on the TV.
O Connect an RCA pin-type video cable tc the VIDEO OUT
terminal on the back of the VCR. Connect the other end of this
cable to the VIDEO INPUT terminal on the back of the televi-
sion.
If you are connecting a Super _rHS (S-VHS)VCR, use an S-Video
cable instead of an RCA pin-type video cable. Connect this S-Video
cable to the S-VIDE0 OUT terminal on the VCR. Connect the other
end of this cable to the S-VIDEO INPUT terminal on the back of
the TV.
O Connect a set of RCA pin-type audio cables to the AUDIO OUT
terminals on the back of the VCR. Use the red cable tc connect
the right (R) channel and the white cable for connecting the left
(L) channel.
Connect the other ends of these cables r2 the AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo), you on:[y need to connect a
single RCA pin-type audio cable. Connect t:he cable to the VCR,
then connect the other end to the L (LEFT) audio input on the back
of the TV.
If your VCR has a video channel switch with an "0FF/AV" position,
set it that position. See your VCR's owner's gaide for details.
Start playing a tape on your VCR.
Use the INPUT button on :your TV's remote control to select
Input-1.
Basic Connections 29