Filter
Top Products
TV + VCR + cable with a decoder box (cont.)
Important:
Important:
Important:
procedure
O Connect the incoming cable to the IN terminal on the two-way
splitter.
O Connect a coaxial decoder box to one of the OUT terminals on
the two-way splitter. Connect the other end of this cable to the
antenna terminal on the back of the TV.
Connect a second coaxial cable to the other OUT terminal on
the two-way splitter. Connect the other end of this cable to the
IN terminal on the decoder box.
O Connect a third coaxial cable to the OUT terminal of the
decoder box; connect the other end of this cable to the
ANTENNA-IN terminal oil the back of the VCR.
Connect an RCA pin video cable to the VIDEO OUT teizninal
on the back of the VCR. Connect the other end of this cable to
the VIDEO INPUT terminal on the back of the TV.
If you are connecting an S-VHS VCR, use an S-Video cable instead
of an RCA pin-type video cable. Connect this S-Video cable to the
S-VIDEO OUT terminal on the VCR. Connect the other end of this
cable to the S-VIDEO INPUT terminal on the back of the _V.
O Connect a set of RCA pin-type audio cables to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and the white cable tbr connecting the left
(L) channel.
Connect the other ends of these cables to the AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo), you only need to connect a
single RCA pin-type audio cable. Connect the cable to the VCR,
then connect the other end to the L (LEFT) audio input on the back
of the TV.
If your VCR has a video channel switch with an "OFF/AV" position,
set it that position. See your VCR's owner's guide for details.
Start playing a tape on your VCR.
Use the INPUT button on your TV's remote control to select
Input-1.
32 Chapter 2: Connecting Your TV