Filter
Top Products
Troubleshooting (cont.)
Problems Possible Solutions For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select button
is set to "TV."
Be sure that you are point-
ing the tip of the remote
control toward the TV from
a distance of no more than
20 feet.
See "Getting ready to use
the remote control" in
Chapter 1 for an explanation
of how to install batteries in
the remote control.
See "Remote control buttons
and fu_ctions" in Chapter 1,
which explains where the
select buttons are located.
See "Getting ready to uae
the remote control" in
Chapter 1, which contains
pointers for using the remote
control
The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 3, which explains
the function of the ENTER
button.
You can't access a channel.
Be sure that the channel you
want to view is programmed
into memory.
Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Memorizing channels"
in Chapter 3, which explains
how to program channels
into the TV's memory.
See "Selecting the input
source" in Chapter 3, which
explains how to change the
input source.
You can't see a different
picture in l_he reduced PIP
image.
• Use the SOURCE button to
select the picture from your
VCR.
• Turn on your VCR and
select a channel different
from the one on your TV.
• See "Using the Advanced
Picture-in-Picture (:PIP)
Modes:" one page 72.
80 Chapter 5: Troubleshooting