Mitsubishi Electronics -LD62D Universal Remote User Manual


 
106
10.3 Program Example with the Coincidence Detection
Interrupt Function
This section describes a program example to start an interrupt program at coincidence detection in CH1 Coincidence
detection point No.1.
(1) System configuration
The system configuration is the same as the following.
System configuration (Page 88, Section 10.1 (1))
(2) Programming condition
(a) Interrupt pointer setting
Project window [Parameter] [PLC Parameter] [PLC System]
"Intelligent Function Module Setting" button
(b) User devices
Device Description
D20 to D35 Interrupt enable flag storage for IMASK instruction