Mitsubishi Electronics -LD62D Universal Remote User Manual


 
39
CHAPTER 6 INSTALLATION AND WIRING
6
6.2 Wiring
6.2.2 Connectors for external devices
6.2.2 Connectors for external devices
(1) Precautions
Tighten the connector screws within the specified torque range.
Use copper wires having temperature rating of 75 or more for the connectors.
Use UL listed connectors if necessary for UL compliance.
(2) Applicable connectors
Connectors for external devices that are applicable to the high-speed counter module need to be obtained by a
user.
The following tables list the applicable connectors, and the reference product of a crimping tool.
(a) 40-pin connectors
The A6CON3 (IDC type connector (straight type)) cannot be used.
(b) 40-pin connector crimping tool
For how to wire the connector and how to use the crimping tool, contact the manufacturer.
Screw Tightening torque range
Connector screw (M2.6) 0.20 to 0.29Nm
Type Model Applicable wire size
Soldering type connector
(straight out type)
A6CON1 0.3 (22 AWG) (Stranded)
Crimping type connector
(straight type)
A6CON2 0.088 to 0.24 (28 to 24 AWG) (stranded wire)
Soldering type connector
(dual purpose (straight/oblique) type)
A6CON4 0.3 (22 AWG) (Stranded)
Type Model Contact
Crimping tool FCN-363T-T005/H
FUJITSU COMPONENT LIMITED
www.fcl.fujitsu.com/en