Filter
Top Products
53
CHAPTER 7 SETTINGS
7
7.1 Adding a Module
CHAPTER 7 SETTINGS
This chapter describes how to configure settings of the high-speed counter module.
● After writing the contents of the new module, parameter settings, and auto refresh settings into the CPU module, reset
the CPU module and switch its status as STOP RUN STOP RUN, or turn off and on the power supply to activate
the settings.
● After writing the contents of the switch settings, reset the CPU module or turn off and on the power supply to activate the
settings.
7.1 Adding a Module
Add the model name of the high-speed counter module used for the project.
(1) How to add a module
Open "New Module".
Project window [Intelligent Function Module] Right-click [New Module...]
Item Description
Module Selection
Module Type Select "Counter Module".
Module Name Select the model name of the module to be connected.
Mount Position
Mounted Slot No. Select the number of the slot where the module is mounted.
Specify start XY
address
The start I/O number (hexadecimal) of the module mounted on the slot set to
"Mounted Slot No." is displayed. This item can be set by user.
Title Setting Title Enter a title.