Mitsubishi Electronics -LD62D Universal Remote User Manual


 
93
CHAPTER 10 PROGRAMMING
10
10.1 Using the Module in Standard System Configuration
(d) Program example
To use each function, insert the following program into the position "A" in the program above.
Using the count disable function
Using the latch counter function
Using the sampling counter function
Using the periodic pulse counter function
CH1 Coincidence signal No.1 reset
command (Y30) is set or reset.
<Start of counting>
The LED indicating a match is turned on.
CH1 Coincidence signal No.1 reset
command (Y30) is set.
CH1 Coincidence signal No.1 reset
command (Y30) is reset.
CH1 Preset command (Y31) is set
or reset.
This program is set only when linear
counter is used.
<Stop of counting>
<Setting for external output of the counter value coincidence signal>
<Processing for counter value coincidence>
<Preset execution (by program)>
<Overflow detection>
A