Filter
Top Products
Chapter 3: NetCommand® Setup and Editing
46
Edit NetCommand
®
:
Delete Devices
Delete Device Screen
Figure 25
Selecting Delete from the Setup menu, displays the
Delete screen. You can choose to delete a single device
by selecting the device you would like to delete, or you
can delete the entire NetCommand configuration. After
you have chosen the device, or the entire configuration,
you will be prompted to confirm your choice to delete.
If you select the Entire Configuration, the Initial button
becomes available on the Edit NetCommand screen. If
you delete a device that you learned the remote control
signals for the learned signals are erased.
Figure 25. Delete screen
Edit NetCommand
®
:
Finish Screen
Figure 26
To finalize your selections and complete the
NetCommand setup, select Finish from the Finish
screen.
Note: To change any of the inputs or names for the
devices, or add devices not included in the initial settings,
select Edit to display the Edit NetCommand menu.
Figure 26. Finish screen
Setup Reminder Screen
Figure 27
This screen only appears if you did not set up
NetCommand when the TV was first turned on. The
Setup Reminder screen displays each time you power on
the TV for six times.
If you would like to set up NetCommand and/or the TV
Guide On Screen system, select Next and press ENTER.
If you do not wish to setup NetCommand and/or the TV
Guide On Screen system, then select Cancel and press
ENTER.
Refer to the separate TV Guide On Screen Interactive
Program Guide System manual for details on using
the TV Guide On Screen system and special guide
customization instructions.
Figure 27. Setup Reminder screen